Tracker 2WD L4-1.6L VIN 6 (2000)
6. Note the position of the upper timing marks (1,2). If the upper timing marks are not aligned as illustrated, rotate the crankshaft clockwise one
revolution until the upper and lower timing marks are properly aligned.
7. Loosen the timing belt tensioner bolt (4).
8. Remove the timing belt tensioner spring from the timing belt tensioner plate (1).
9. Remove the timing belt from the camshaft and the crankshaft timing belt gears.
Notice: Do not turn the crankshaft and camshaft independently of one another once the timing belt has been removed. If the crankshaft or camshaft is
turned independently, interference between the pistons and valves may occur causing component damage.
10. Inspect the timing belt tensioner for smooth operation. Replace the timing belt tensioner if necessary. Refer to Timing Belt Tensioner
Replacement.
Installation Procedure
Notice: When installing a new or used timing belt, the directional arrows on the timing belt must be matched with the rotation of the crankshaft. If
this precaution is not observed, excessive wear and timing belt failure may occur.
Important: Do not tighten the timing belt tensioner stud and bolt to specification until the timing belt is properly installed. Install the timing belt
tensioner stud and bolt finger tight only.
