Tracker 2WD L4-1.6L VIN 6 (2000)
Tighten
Tighten the evaporator case mounting bolts and nuts to 10 N.m (89 lb in).
7. Connect the evaporator temperature sensor electrical connector to the compressor control module.
8. Install new O-rings to the evaporator pipe fittings. Coat the new O-rings with mineral base 525 viscosity refrigerant oil.
9. Connect the evaporator inlet and outlet pipes at the bulkhead. Slide the plate (2) clockwise and secure with the bolt (1).
10. Install the instrument panel carrier.
11. Enable the SIR.
12. Connect the negative (-) battery cable.
13. Evacuate and recharge the air conditioning system. Refer to Refrigerant Recovery and Recharging. See: Refrigerant/Service and Repair
14. Operate the A/C system and inspect for refrigerant leaks. Refer to Leak Testing. See: Testing and Inspection/Component Tests and General
Diagnostics/Leak Testing
