Tracker 2WD L4-1.6L VIN 6 (2000)
9. Strip 13 mm (0.5 in) of insulation from both ends of the wires.
10. Twist together one end from each of the wires in order to short the wires. Deployment wires shall remain shorted, and not connected to a power
source until you are ready to deploy the air bag.
11. Twist together one connector wire lead to one deployment wire.
12. Bend flat the twisted connection.
13. Secure and insulate the connection using electrical tape.
14. Twist together, bend, and tape the remaining connector wire lead to the remaining deployment wire.
15. Connect the deployment harness to the inflatable restraint steering wheel module yellow 2-way connector.
16. Route the deployment harness out of the driver side of the vehicle.
