Tracker 2WD L4-1.6L VIN 6 (2000)
Camshaft Position Sensor: Service and Repair
REMOVAL PROCEDURE
1. Remove the CMP sensor electrical connector (2).
2. Disconnect the ground strap.
3. Remove the CMP sensor retaining bolt (1).
4. Remove the CMP sensor (3).
INSTALLATION PROCEDURE
1. Apply a thin coat of engine oil to the sensor O-ring.
2. Install a CMP sensor (3).
NOTE: Refer to Fastener Notice in Cautions and Notices.
3. Install the retaining bolt (1).
Tighten
Tighten the retaining bolt to 9 N.m (78 lb in).
4. Reconnect the CMP sensor electrical connector (2).
5. Reconnect the ground strap.
