Tracker 2WD L4-1.6L VIN 6 (2000)
Wheel Fastener: Service and Repair
Front
Installation Procedure
1. Align the serrations in the wheel bolts (2) with the serrations in the bolt holes. Use a hydraulic press (1) in order to install the 5 wheel bolts.
2. If the vehicle has ABS, install the wheel speed sensor ring. Refer to Wheel Speed Sensor Ring Replacement-Front in Antilock Brake System.
3. Install the hub, the bearings, and the seals. Refer to Wheel Hub, Bearing, and Seat Replacement.
4. Install the brake rotor. Refer to Brake Rotor Replacement in Disc Brakes.
5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
6. Lower the vehicle.
Removal Procedure
^
Tools Required
-
J6627-A Wheel Stud Remover
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Remove the brake rotor. Refer to Brake Rotor Replacement in Disc Brakes.
4. Remove the hub with the bearings and the seals. Refer to Wheel Hub, Bearing, and Seal Replacement.
5. If the vehicle has ABS, remove the wheel speed sensor ring from the hub. Refer to Wheel Speed Sensor Ring Replacement-Front in Antilock
Brake System.
6. Use the J6627-A in order to remove the 5 wheel bolts from the hub (1).