Tracker 2WD L4-1.6L VIN 6 (2000)
11. Clean around the edge of the inside surface of the window with a 50/50 mixture of isopropyl alcohol and water by volume on a dampened lint free
cloth.
Important: Do not remove all traces of the adhesive. Remove all mounds or loose pieces of urethane adhesive .
12. If the extended method is being used remove all but approximately 2 mm (3/64 in) of the existing bead of adhesive from the pinchweld flange.
13. Shake the pinchweld primer (black #3) for at least one minute.
14. Use a new dauber to apply the primer to the surface of the pinchweld flange.
15. Allow the pinchweld primer to dry for approximately 10 minutes.
16. If the extended method is being performed, do the following:
Important: Use care when applying the prep (clear #1) to rear door window. This primer dries almost instantly and may stain the
viewing area of the rear window if not applied evenly.
17. If installing a new non encapsulated window:
1. Use a new dauber, to apply the rear window prep (clear #3) to the area approximately 10 to 16 mm (3/8 to 5/8 in) around the entire perimeter
of the rear window inner surface.
2. Apply rear window prep (clear #1) to the same area of the glass.
3. Wipe the glass primed area immediately with a clean lint free cloth.
4. Shake the glass primer (black #2) for at least one minute.
18. If installing a new encapsulated window:
*
Use a new dauber, in order to apply the window prep (clear #3) to the area approximately 10 to 16 mm (3/8 to 5/8 in) around the entire
perimeter of the rear glass inner surface. The glass must be installed within 8 hours after applying the primer to the glass.
*
The primed surface of the glass must be kept clean.
*
Allow the glass primer to dry for approximately 10 minutes.
19. Shake the rear window primer (black #2) for at least one minute.
20. Use a new dauber, in order to apply the rear window primer (black #2) to the areas of the rear window (1) to which prep (clear #1) was applied.
21. Allow the primer to dry for approximately 10 minutes.
