Tracker 2WD L4-2.0L VIN C (1999)
Brake Drum: Service and Repair
Brake Drum Replacement
REMOVAL PROCEDURE
1. Ensure the park brake lever is released.
2. Remove the 4 screws (1,3,4,6), the 2 clips (2,5), and lift up the console.
3. Loosen the parking brake cable lock nut (2).
4. Raise and support the vehicle.
5. Remove the tire and wheel assembly.
6. Remove the locking washers from the wheel studs.
7. Remove the drum (1) from the axle hub. If the drum cannot be removed by hand, install two 8 mm bolts (2) into the drum. Tightening the bolts
will force the drum off the hub.
