Tracker 2WD L4-2.0L VIN C (1999)
Important:
^
Store the valve lifters so that they can be installed in the same bore from which they were removed.
^
Do not disassemble the valve lifter.
^
Do not apply force to the body (valve side) of the valve lifter, this will force oil to leak out of the valve lifter.
^
Store the valve lifters submerged in clean engine oil camshaft side down until installation.
^
Store the valve lifters camshaft side up if left in air until installation. Do not store in air with the camshaft side down or on the valve lifter side.
8. Remove the valve lifters.
Inspection Procedure
^
Tool(s) Required
-
J 26900-2 Outside Micrometer 0-2 inch
-
J 8001 Dial Indicator Set
-
J 26900-13 Magnetic Base
1. Measure the camshaft lobe height using the J 26900-2. Replace the camshaft if any lobe is below the minimum.
Standard Intake Camshaft Lobe Height: 40.402-40.562 mm (1.5906-1.5969 inch)
Minimum Intake Camshaft Lobe Height: 40.202 mm (1.5827 inch)
