Tracker 2WD L4-2.0L VIN C (1999)
6. Install the dowel pins (1) to the cylinder head.
7. Apply a bead of GM P/N 12346240 or equivalent to the exhaust camshaft end housing (2).
Important: Cylinder head and camshaft damage may result if the bearing caps are incorrectly installed.
8. Install the camshaft bearing caps. The caps are marked intake or exhaust (1), position away from the timing chain (2), and direction toward the
timing chain (3).
Notice: Refer to Fastener Notice in Service Precautions.
9. Tighten the camshaft bearing caps.
Tighten the camshaft bearing caps in 3 progressive steps in the sequence shown to 11 Nm (97 inch lbs.).
10. Align the matchmarks and install the Camshaft Position (CMP) sensor. The sensor shaft is offset and can only be installed 1 way. Secure the CMP
with the bolt.
11. Install the exhaust camshaft sprocket and the timing chain.
12. Install the timing chain housing.
Important:
