Tracker 2WD L4-2.0L VIN C (1999)
Notice: The block heater element must not touch the engine block inner wall in the installed position or damage to the engine block and the block
heater could result.
2. Insert the engine coolant heater into the hole in the engine block (2).
3. Install the engine coolant heater retainer bracket over the engine coolant heater, with the bent tabs facing the engine.
Notice: Refer to Fastener Notice in Service Precautions.
4. Tighten the engine cooler heater screws.
Tighten the engine coolant heater screws to 14 Nm (10 ft. lbs.).
5. Install the heat shield to the exhaust manifold.
6. Connect the electrical cord connector to the engine coolant heater.
Caution: A block heater electrical cord that is damaged creates a shock hazard, and must be replaced.
Notice: The heater cord must not touch the engine, hot pipes, manifold, or any moving parts. Route the cord to the left front of the engine
compartment securing with tie straps as necessary to prevent damage.
Important: Do not secure the block heater cord to the brake, fuel or vacuum lines. The cord and the tie straps could chafe the lines and lead to
corrosion on the lines.
7. Route and secure the cord.
8. Fill the cooling system.
9. Inspect the cooling system for leaks.
