Tracker 2WD L4-2.0L VIN C (1999)
Drive Belt Noise
Drive belt noise may be described as a thumping noise heard at, or just above idle speed, as a result of drive belt pilling. In a single-belt drive, drive
belt pilling occurs when small particles of drive belt material separate from the drive belt grooves, and form small balls or pills in the drive belt
grooves. While some drive belt pilling is normal, excessive pilling can cause a thump or knocking as the pills pass over various drive belt pulleys. This
causes the drive belt to repeatedly jump off of and slap onto the drive belt pulley.
The thump or knocking noise easily misdiagnosed as an engine noise. In order to diagnose drive belt pilling, adhere to the following procedure:
1. Remove the drive belt.
2. Run the engine for no more than 30 to 40 seconds, in order to confirm that the engine noise disappears.
3. Inspect the power steering pulley for proper alignment.
4. Inspect all other pulleys for excess paint, debris or pills in the grooves.
