Tracker 2WD L4-2.0L VIN C (1999)
1. Install new O-rings and install the oil pump strainer to the oil pump.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install and tighten the 2 strainer bolts first and then the bracket bolt.
Tighten the 3 bolts to 11 Nm (97 inch lbs.).
3. Apply a continuous bead of silicon sealant (1) GM P/N 12345997, or an equivalent, to the engine oil pan mating surface.
4. Install the engine oil pan. Secure with the 16 bolts and 2 nuts.
Tighten the engine oil pan bolts and nuts to 11 Nm (97 inch lbs.).
5. Install the engine oil gasket and drain plug.
Tighten the engine oil drain plug to 35 Nm (26 ft. lbs.).
6. Install the flywheel cover.
