Tracker 2WD L4-2.0L VIN C (1999)
1. Hold back the latch, compress the plunger and install a retainer (a paper clip or similar tool) to hold the plunger in place.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the timing chain tensioner.
Tighten the 2 bolts (1) to 11 Nm (97 inch lbs.).
3. Remove the retainer.
4. Turn the crankshaft 2 revolutions realigning the keyway on the crankshaft (5) with the timing mark on the engine block (4).
5. Ensure that the guide pins on the camshafts (1) are in line with the notches on the cylinder head (6).
6. Apply engine oil to the following:
^
The timing chains
^
The tensioner
^
The guides
^
The sprockets
7. Install the spark plugs.
