chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Heating and Ventilation|Page 7131 > < Heating and Ventilation|Page 7129
Page 3
background image

2. Remove the heater control assembly (6) from the Instrument Panel (IP) in order to gain access to the cable. Do not remove the heater control

assembly from the vehicle.

3. Gently pry the mode control cable (4) sheath from the heater control unit. Unhook the cable from the lever arm.

IMPORTANT:  Note the routing position of the cable in order to facilitate installation.

4. Remove the mode control cable from the instrument panel.

INSTALLATION PROCEDURE

1. Route the mode cable (4) into the instrument panel as previously noted.
2. Hook the end of the cable into the hole in the lever arm.
3. Slide the sheath back on the cable.
4. Line up the sheath with the sheath retainer.
5. Slide the sheath into its retainer until it snaps into place.

Heating and Ventilation|Page 7131 > < Heating and Ventilation|Page 7129