Tracker 2WD L4-2.0L VIN C (1999)
1. Install the bulb to the socket.
2. Install the bulb socket (2).
3. Install the heater control fascia (4) to the control assembly.
4. Install the knobs (1) to the levers.
5. Install the IP cluster trim bezel.
Control Assembly Replacement
REMOVAL PROCEDURE
1. Remove the mode control cable (3) at the heater case.
2. Disconnect the defroster switch (1), if equipped.
3. Remove the 2 screws and the defroster switch as necessary.
