Tracker 2WD L4-2.0L VIN C (1999)
2WD Front Suspension Sectional View
1. Use your hands in order to lift the front bumper of the vehicle up approximately 38 mm (1.5 inch). Gently remove your hands in order to allow the
vehicle to lower.
2. Use your hands in order to push the front bumper of the vehicle down approximately 38 mm (11.5 inch). Remove your hands in order to allow the
vehicle to rise.
3. Measure the Z dimension for the left and the right side of the vehicle. The Z dimension is the vertical distance measured between the centerline of
the lower control arm rear bolt (2) and the bottom of the ball joint (3).
4. If the Z dimension is not within 10 mm of the specification, replace the front springs.
MEASURING THE D DIMENSION
