Tracker 2WD L4-2.0L VIN C (1999)
3. Connect the following connectors to the rear of the junction block (5):
^
Junction block connector C1 (4)
^
Junction block connector C2 (3)
^
Junction block connector C3 (2)
4. Install the connector housing to the junction block (9) by engaging the retaining tabs (1) at the top of the junction block (9).
NOTE: Refer to Fastener Notice in Cautions and Notices.
5. Install the junction block (9) to the 3 retaining studs. Secure the junction block with the 3 nuts (3,10).
Tighten
Tighten the junction block mounting nuts to 10 N.m (89 lb in).
6. Connect the following electrical connectors to the front of the junction block (9):
^
Junction block connector C4 (4)
^
Junction block connector C5 (5)
7. Install the following connectors to the bottom of the junction block (9):
^
Inline connector C213 (8)
^
Inline connector C205 (7)
^
Inline connector C204 (6)
8. Install the bracket that contains the fuel pump relay and the main relay to the left front side of the junction block (9).
9. Install the IP steering column opening trim plate.
10. Connect the negative battery cable.
