Tracker 2WD L4-2.0L VIN C (1999)
Audio Alarm Module (Chime): Service and Repair
REMOVAL PROCEDURE
The multifunction alarm (1) is located in the upper right corner of the rear of the instrument cluster (2).
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
2. Remove the instrument cluster.
3. Remove the following from the rear of the instrument cluster (2):
3.1. The multifunction alarm retainer
3.2. The multifunction alarm (1)
INSTALLATION PROCEDURE
1. Install the multifunction alarm (1) to the rear of the instrument cluster (2). Secure the alarm with the retainer.
2. Install the instrument cluster.
3. Connect the negative battery cable
