Tracker 2WD L4-2.0L VIN C (1999)
12. Bend flat the twisted connection.
13. Secure and insulate the connection using electrical tape.
14. Twist together, bend, and tape the remaining connector wire lead to the remaining deployment wire.
15. Connect the deployment harness to the Inflatable Restraint Front Side Impact Module (LH) yellow 2-way connector.
16. Route the driver side deployment harness out 0 the driver side of the vehicle.
17. Disconnect the Inflatable Restraint Front Side Impact Module (RH) yellow 2-way harness connector located under the front passenger seat.
18. Cut the harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
19. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
