Tracker 2WD L4-2.0L VIN C (1999)
Accumulator: Service and Repair
1. Remove the fluid level indicator.
2. Disconnect the TV cable from the throttle body.
3. Raise the vehicle. Support the vehicle. Refer to Vehicle Lifting.
4. Remove the front propeller shaft. Refer to Propeller Shaft Replacement - Front
5. Remove the fluid pan bolts (3) the fluid pan and the gasket (2). Refer to Automatic Transmission Fluid/Filter Changing.
6. Disconnect the TV cable (3) from the TV cable cam (2).
7. Remove the electrical connectors from the torque convertor (TCC) solenoid and the shift solenoid assembly.
8. Remove the 1 bolt and the solenoid wiring harness.
9. Remove the valve body filter and gasket.
10. Remove the 14 bolts that attach the valve body (1) to the transmission case.
11. Apply low compressed air slowly to the fluid passages until the air pressure forces the following items out of the case bores:
^
The 2nd brake accumulator
^
The direct clutch accumulator
^
The forward clutch accumulator
