Tracker 2WD L4-2.0L VIN C (1999)
12. Remove the opposite bearing cap by inserting the 18 mm (1) socket through the bearing cap opening in the propeller shaft yoke. Tap on the socket
gently with a hammer until the opposite bearing cap is exposed approximately 3-4 mm (0.12-0.16 in).
13. Remove the opposite bearing cap from the propeller shaft yoke by placing the exposed portion of the bearing cap into a soft-jaw vise. Tap upwards
on the propeller shaft yoke with a hammer until the bearing cap is free of the propeller shaft yoke.
14. Remove the spider from the propeller shaft yoke.
15. Inspect the propeller shaft yoke for the following:
^
Distortion
^
Cracks
^
Other damage
If the propeller shaft yoke appears distorted or damaged, replace the pinion flange yoke. Refer to Propeller Shaft Replacement - Front
16. Inspect the pinion flange yoke for the following:
^
Distortion
^
Cracks
^
Other damage
If the pinion flange yoke appears distorted or damaged, replace the pinion flange yoke.
Important: If any unusual wear or damage is found on any component upon universal joint inspection, do not attempt to repair or replace the
component. Replace the universal joint as an assembly.
17. Inspect the bearing caps (2) for broken or missing needle bearings. If the needle bearing appears missing or worn, replace the universal joint as an
assembly.
18. Inspect the bearing surfaces on the spider for flat spots or excessive wear. If the bearing surfaces on the spider appear worn or flat, replace the
universal joint as an assembly.
Installation Procedure
Notice: During bearing cap installation, make sure that the needle bearings are correctly positioned. If the needle bearings become mispositioned
during installation, damage to the needle bearings and the spider will result.
