Tracker 4WD L4-1.6L VIN 6 (1998)
2. Install the brake motor pack (1) to the brake modulator (2).
3. Install the Torx head screws (6) that attach the Brake Motor Pack (1) to the Hydraulic Modulator (2).
^
Tighten the Torx head screws to 5 Nm (44 inch lbs.).
4. Install the gear cover (4) to the brake modulator (2).
5. Install the Torx (R) head screws (5) that attach the gear cover (4).
^
Tighten the Torx head screws to 4 Nm (36 inch lbs.).
6. Install the brake modulator assembly.
7. Using the scan tool, perform the Motor Rehome Procedure.
8. Perform the Diagnostic System Check