Tracker 4WD L4-1.6L VIN 6 (1998)
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
2. Remove the plugs from the brake pipes and connect the pipes to the brake modulator; secure each brake pipe with one pipe nut.
^
Tighten the pipe nuts to 15 Nm (11 ft. lbs.).
3. Connect the motor pack, ABS solenoids, and the shuttle valve switch electrical connectors.
4. Connect the Negative (-) battery cable.
CAUTION: Before removing or installing any electrical unit or when a tool or equipment could easily come in contact with "live"
exposed electrical terminals, disconnect the negative battery cable to help prevent personal injury and/or damage to the vehicle or
components. Unless instructed otherwise, the ignition switch must be in the "OFF" or "LOCK" position.
IMPORTANT: Bleed the system. Perform the "Diagnostic System Check" in Antilock Brake System. See: Testing and Inspection
