Tracker 4WD L4-1.6L VIN 6 (1998)
2. Charge the J 29532 to 140 to 172 kPa (20 to 25 psi).
3. Connect the J 29532 line to the J 37762 and open the line valve.
4. Raise the vehicle. Support the vehicle.
5. Attach a transparent hose to the bleeder valve (1).
6. Submerge the opposite end of the hose (1) into a clean container (2) that is partially filled with brake fluid. Place a proper size box end wrench
over the bleeder valve. Open the valve at least a one-half to three-quarter turn. Allow the fluid to flow until no air is seen in the fluid. Do not allow
the J 29532 to run out of fluid. If the fluid should run out, air will enter the system and the entire bleeding procedure must be repeated.
7. Close the bleeder valve. Make sure the bleeder valve seals.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
8. Repeat steps 5, 6, and 7 until all of the calipers and wheel cylinders have been bled.
^
Tighten the wheel cylinder/caliper bleeder valve to 16 Nm (12 ft. lbs.).
9. Lower the vehicle.
10. Check for a firm brake pedal action. If the brake pedal appears spongy, repeat the entire procedure.
11. Remove the J 37762 and the J 29532 from the master cylinder.
