Tracker 4WD L4-1.6L VIN 6 (1998)
Brake Pad: Testing and Inspection
1. Inspect the linings when the wheels are removed (tire rotation, etc.).
2. Check both ends of the outer pad (2) by looking through the lining inspection hole in the caliper. These are the points where the highest rate of
wear normally occurs. At the same time, check the thickness of the inner pad to ensure that the inner pad has not worn prematurely. The minimum
thickness of the pad lining material is 2.5 mm (0.10 in).
3. Replace the pads if the minimum thickness has been exceeded.
