Tracker 4WD L4-1.6L VIN 6 (1998)
9. Suspend the caliper/caliper carrier (1) with a wire (2) in order to prevent damage to the brake hose.
10.
Measure the rotor (1) thickness using J26900-1.Replace the rotor if the rotor thickness is less than the following specifications:
-
2-Door: 8.0 mm (0.315- in).
-
4-Door: 15.0 mm (0.590 in).
11. Remove the brake rotor (1) from the wheel hub. If the rotor cannot be removed by hand, install two 8 mm bolts (2) into the rotor. Tightening the
bolts will force the rotor off of the wheel hub.
INSTALLATION PROCEDURE
1. Install the brake rotor to the wheel hub.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
