Tracker 4WD L4-1.6L VIN 6 (1998)
1. Install the brake hose (1) at the brake pipe and caliper (2). Secure the hose with the fitting nut and bolt at the caliper.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
1.1.
^Tighten the brake pipe fitting nuts to 16 Nm (12 ft. lbs.).
1.2.
^Tighten the caliper union bolt to 23 Nm (17 ft. lbs.).
2. Install the brake hose (1) to the strut-mounted bracket. Secure the hose with the E-clip (2).
3. Install the tire and wheel assembly.
4. Lower the vehicle.
5. Flush and bleed the brake system.
