Tracker 4WD L4-1.6L VIN 6 (1998)
2. Disconnect the pipe(s) (1) to be replaced at each fitting.
3. Remove the pipe(s) (1) from the guide brackets (3).
4. Remove the pipe(s) (1) from the vehicle.
INSTALLATION PROCEDURE
1. Install the brake pipe(s) (1) to each fitting.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
2. Secure the pipes with guide brackets (3) and pipe fitting nuts (2).
^
Tighten the brake pipe fitting nuts (2) to 16 Nm (12 ft. lbs.).
3. Flush the brake system.
Pipe Replacement (Front Without ABS)
REMOVAL PROCEDURE
1. Clean any dirt and foreign materials from the pipes and fittings.