Tracker 4WD L4-1.6L VIN 6 (1998)
Wheel Cylinder: Service and Repair
Wheel Cylinder Replacement
REMOVAL PROCEDURE
1. Remove the linings.
2. Clean dirt and foreign material from the wheel cylinder and the brake fluid pipe.
3. Loosen the brake fluid pipe(s) (1) from the back of the wheel cylinder by loosening the flare nut(s) but only to the extent that brake fluid does not
leak.
4. Remove the two wheel cylinder retaining bolts from the rear of the backing plate (2).
5. Disconnect the brake pipe(s) (1) from the wheel cylinder.
6. Remove the bleeder valve cap and install it on the end of the brake fluid pipe (2) to prevent leaks or contamination.
7. Remove the wheel cylinder from the vehicle.
INSTALLATION PROCEDURE
1. Install the wheel cylinder gasket (2) to the wheel cylinder (1).