Tracker 4WD L4-1.6L VIN 6 (1998)
Vacuum Brake Booster: Service and Repair
Vacuum Brake Booster Replacement
REMOVAL PROCEDURE
^
Tools Required
-
J 39567 Booster Push Rod Gauge
-
J 37767 Booster Push Rod Wrench
1. Remove the master cylinder.
2. Remove the hose clamp and the hose (8) from the booster (1).
3. Remove the following components from the push rod clevis (4).
-
The cotter pin (3)
-
The clevis pin (5)
4. Remove the push rod clevis (5) from the brake pedal.
5. Remove the following components from the bulkhead:
-
Four mounting bolts (2)
-
The booster assembly
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
