Tracker 4WD L4-1.6L VIN 6 (1998)
Electronic Brake Control Module: Service and Repair
Relay Replacement
REMOVAL PROCEDURE
The electronic brake control relay is located on the left hand side of the engine compartment, on the inner fender next to the hydraulic modulator.
1. Disconnect the Negative (-) battery cable.
CAUTION: Before removing or installing any electrical unit or when a tool or equipment could easily come in contact with "live"
exposed electrical terminals, disconnect the negative battery cable to help prevent personal injury and/or damage to the vehicle or
components. Unless instructed otherwise, the ignition switch must be in the "OFF" or "LOCK" position.
2. Pull the relay (2) from the mounting bracket.
3. Disconnect the relay (2) from the relay harness connector.
INSTALLATION PROCEDURE
1. Connect the Relay (2) to the relay harness connector.
2. Install the Relay (2) to the mounting bracket.
3. Connect the Negative (-) battery cable.
CAUTION: Before removing or installing any electrical unit or when a tool or equipment could easily come in contact with "live"
exposed electrical terminals, disconnect the negative battery cable to help prevent personal injury and/or damage to the vehicle or
components. Unless instructed otherwise, the ignition switch must be in the "OFF" or "LOCK" position.
4. Perform the Diagnostic System Check
