Tracker 4WD L4-1.6L VIN 6 (1998)
IMPORTANT: It is not necessary to remove the crankshaft pulley center bolt when removing the crankshaft pulley (3).
9. Remove the five bolts and the crankshaft pulley (3) from the crankshaft.
10. Remove the timing belt.
11. Loosen the A/C compressor drive belt (if equipped).
12. Remove one bolt and the engine oil level indicator tube, with the O-ring, from the oil pump.
13. Remove the generator mounting bolt and bracket at the coolant pump.
14. Remove the timing belt tensioner (5) and pulley (3).
15. Remove the five coolant pump mounting bolts and the coolant pump (1) with the gasket (2) and rubber seals from the engine.
16. Clean the gasket material, corrosion and debris from the mating surfaces on the coolant pump (1) and the engine block.
INSTALLATION PROCEDURE
NOTICE: Refer to Fastener Notice in Service Precautions.
