Tracker 4WD L4-1.6L VIN 6 (1998)
Camshaft: Service and Repair
REMOVAL PROCEDURE
^
TOOLS REQUIRED
-
J 41040 Camshaft Sprocket Spanner Wrench
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Release the fuel pressure.
3. Remove the fuel filler cap in order to release the fuel vapor pressure in the fuel tank.
4. Replace the cap after the pressure has been released.
5. Drain the cooling system.
6. Remove the air intake pipe from the Air Cleaner (ACL) intake hose and the throttle hose.
7. Remove three bolts and the throttle cover from the intake manifold.
8. Disconnect the accelerator cable (3) and kickdown cable (4) (automatic transmission equipped vehicles) from the throttle body bellcrank (1).
9. Remove the following from the throttle body:
^
One bolt
^
One nut
^
One screw
^
The accelerator cable bracket (2)
10. Remove the following electrical connectors:
^
(TP) Sensor
^
(IAC) Valve
^
(ECT) Sensor (4)
^
ECT Sending Unit
^
A/C ECT Switch (3) (A/C equipped vehicles only)
^
(EVAP) Canister Purge Valve
^
(EGR) Temperature Sensor
^
EGR Solenoid Vacuum Valve
^
EGR By-pass Valve
^
Fuel Injectors
^
Engine Ground Wire From Intake Surge Tank (7)