Tracker 4WD L4-1.6L VIN 6 (1998)
6. Install the camshaft and the camshaft carrier caps (1) onto the cylinder head.
7. Secure the camshaft and the camshaft carrier caps with 12 bolts.
^
Tighten the camshaft carrier cap to 10 Nm (89 inch lbs.).
8. Apply engine oil to the new camshaft seal lip.
9. Install the new camshaft seal into the cylinder head until the camshaft seal is flush with the camshaft carrier surface.
10. Adjust the valve lash.
11. Apply GM P/N 12346340 or the equivalent to the surface of the distributor case (1) that mates with the rear rocker arm shaft.
12. Install the distributor case to the cylinder head.
13. Secure the distributor case with three bolts.
^
Tighten the distributor case bolts to 10 Nm (89 inch lbs.).
14. Clean the sealing surfaces on the cylinder head and the cylinder head cover.
IMPORTANT: A new cylinder head cover gasket and O-rings must be used whenever a cylinder head cover removal and installation is
performed. Ensure that new gasket and O-rings are correctly positioned during the cylinder head cover installation.
15. Install a new head cover gasket and four O-rings (2) to the cylinder head cover (1).
16. Install the cylinder head cover to the cylinder head.
17. Secure the cylinder head cover with six bolts.
^
Tighten the cylinder head cover bolts to 10 Nm (89 inch lbs.).
18. Install the distributor into the distributor case.
