Tracker 4WD L4-1.6L VIN 6 (1998)
8. Install the crankshaft pulley (4) to the crankshaft. Secure the pulley with five bolts (3).
^
Tighten Crankshaft pulley bolts to 16 Nm (12 ft. lbs.).
9. Install the radiator shroud to the radiator. Secure the shroud with two bolts.
^
Tighten the upper shroud bolts to 11 Nm (97 inch lbs.).
10. Carefully reposition the A/C suction line and brackets to the right side of the radiator core support (if equipped). Secure the line and brackets with
two bolts.
^
Tighten the A/C suction line bracket bolts to 10 Nm (89 inch lbs.).
11. Raise and support the vehicle.
12. Install the two lower radiator shroud bolts.
^
Tighten the lower shroud bolts to 11 Nm (97 inch lbs.).
13. Install the front skid plate to the vehicle (if equipped). Secure the skid plate with four bolts.
^
Tighten the Front skid plate bolts to 55 Nm (40 ft. lbs.).
14. Lower the vehicle.
15. Install the coolant pump pulley and cooling fan to the coolant pump. Secure the pulley and fan with four nuts.
^
Tighten the coolant fan nuts to 11 Nm (97 inch lbs.).
16. Install the generator/coolant pump drive belt to pulleys.
17. Install the A/C compressor (if equipped) and/or power steering drive belt to pulleys.
^
Adjust the generator/coolant pump drive belt.
^
Adjust the A/C compressor (if equipped) and/or the power steering drive belt.
18. Connect the negative battery cable.
