Tracker 4WD L4-1.6L VIN 6 (1998)
12. Remove the engine hanger (3) from the cylinder head.
13. Remove the two bolts and lower the exhaust manifold heat shield (6) from the exhaust manifold (2).
14. Remove the Heated Oxygen (H02S1) Sensor (4) from the exhaust manifold (2).
INSTALLATION PROCEDURE
NOTICE: Refer to Fastener Notice in Service Precautions.
1. Install the Heated Oxygen (H02S1) Sensor into the exhaust manifold.
^
Tighten the (H02S1) Sensor to 43 Nm (32 ft. lbs.).
2. Install the new exhaust manifold gasket (1) and the exhaust manifold (2) with the engine hanger.