Tracker 4WD L4-1.6L VIN 6 (1998)
Remove or Disconnect
1. Fresh/recirc control cable at the blower case.
2. Heater control unit.
Important
^
Note routing position of cable to make installation easier.
3. Fresh/recirc control cable at heater control unit.
4. Fresh/recirc control cable from I/P.
Install or Connect
1. Fresh/recirc control cable to heater control unit.
2. Heater control unit to I/P.
3. Position fresh/recirc control cable in vehicle; route cable as previously noted.
Adjust
^
Fresh/recirc control cable.