Tracker 4WD L4-1.6L VIN 6 (1998)
1. Install new O-rings to refrigerant pipe fittings. Coat new O-rings with clean refrigerant oil.
2. Receiver/dryer-to-evaporator (evaporator inlet) pipe at evaporator inlet bulkhead fitting (one nut).
3. Pipe at receiver/dryer fitting (one bolt).
Tighten
^
Evaporator inlet pipe nut to 35 N.m (26 lb. ft.).
^
Receiver/dryer pipe fitting bolt to 35 N.m (26 lb. ft.).
4. EVAP canister.
5. Negative (-) battery cable.
6. Evacuate and recharge air conditioning system.
7. Operate A/C system and check for refrigerant leaks.
