Tracker 4WD L4-1.6L VIN 6 (1998)
Receiver Dryer: Service and Repair
Important
^
When installing a new receiver/dryer, 10 mL (0.3 fl. oz.) of refrigerant oil must be added to the refrigeration system.
Remove or Disconnect
1. Discharge and recover refrigerant.
2. Negative (-) battery cable.
3. A/C dual pressure switch electrical connector.
4. Receiver/dryer inlet and outlet pipes at fittings.
5. Two screws and receiver/dryer from mounting bracket.
Install or Connect
1. Receiver/dryer to mounting bracket; secure with two screws.
2. Receiver/dryer inlet and outlet pipes at fittings; secure with pipe bolt.
Tighten
^
Receiver/dryer pipe fitting bolts to 35 N.m (26 lb. ft.).
3. A/C dual pressure switch electrical connector.
4. Negative (-) battery cable.
5. Evacuate and recharge air conditioning system.
6. Operate A/C system and check for refrigerant leaks.