Tracker 4WD L4-1.6L VIN 6 (1998)
Daytime Running Lamp Resistor: Service and Repair
REMOVAL PROCEDURE
1. Raise and suitably support the vehicle.
2. Remove the following components from the right front fender:
^
The 2 screws
^
The 6 plastic screws
^
The 1 push clip
^
The wheelhousing
3. Remove the 2 washer fluid reservoir screws.
4. Set aside the washer fluid reservoir.
5. Remove the 2 DRL resistor nuts (2).
6. Reposition the DRL resistor (3).
7. Disconnect the DRL electrical connector (2).
8. Remove the DRL resistor (3) from the vehicle.
