Tracker 4WD L4-1.6L VIN 6 (1998)
11. Remove the ten pipe retaining clamps (2) from the fuel pipes.
12. Remove the fuel pipes (1) from the vehicle underbody.
Installation Procedure
1. Install the fuel pipes to the underbody.
2. Secure the fuel pipes with ten pipe retaining clamps.
3. Connect the fuel vapor hose to the fuel vapor pipe in the engine compartment.
4. Connect the fuel return hose to the fuel return pipe in the engine compartment.
5. Connect the fuel feed hose to the fuel feed pipe in the engine compartment.
6. Secure the fuel feed hose with one bolt and tighten to 45 Nm (33 lb ft).
7. Connect the fuel vapor hose to the fuel vapor pipe by the fuel tank.
8. Connect the fuel feed outlet hose to the fuel feed pipe by the fuel tank.
9. Secure the fuel feed outlet hose with one bolt and tighten to 45 Nm (33 lb ft).
10. Connect the fuel return hose to the fuel return pipe by the fuel tank.
11. Lower the vehicle.
12. Connect the negative battery cable.
13. Turn the Ignition switch to the ON position and then to OFF to pressurize the fuel system.
14. Check for any fuel leaks, repair as necessary.
