Tracker 4WD L4-1.6L VIN 6 (1998)
Description
4. Pull the rear quarter interior trim panel (1) from the vehicle, disengaging the plastic clips.
5. Remove one mounting bolt and the front seat belt retractor mechanism from the vehicle.
4 Door
Description
CAUTION: The seat belt assembly and/or bracket assembly must be replaced as a unit only. Do not substitute parts for any reason, or
personal injury could result.
CAUTION: Replace belts, retractors, and hardware in use during all but a minor collision. Also, restraint systems should be replaced and
anchorages properly repaired if they were in areas damaged by collision, whether the belt was in use or not. If there is any question, replace the
belt system. Damage, whether visible or not, could result in serious personal injury in the event of an accident.
1. Push the carpet away to gain access to the front seat belt lower anchor bolt (2).
2. Remove the anchor bolt (2).
3. Remove the three screws and the front side door scuff plate.
4. Remove the two screws and the rear side door scuff plate.
5. Remove the A-pillar trim from the A-pillar.
6. Remove one mounting bolt and front seat belt retractor mechanism from the vehicle.
2 Door
NOTICE: Refer to Fastener Notice in Service Precautions.
