Tracker 4WD L4-1.6L VIN 6 (1998)
Door Switch: Service and Repair
Door Jamb Switch Replacement - Rear
REMOVAL PROCEDURE
1. Remove the rubber boot from the rear door jamb switch.
2. Remove the rear body side lower trim panel.
3. Disconnect the rear door jamb switch electrical connector.
4. Remove the rear door jamb switch from the vehicle.
INSTALLATION PROCEDURE
1. Connect the rear door jamb switch electrical connector.
2. Install the rear door jamb switch to the door jamb.
3. Install the rubber boot to the rear door jamb switch.
4. Install the rear body side lower trim panel.