Tracker 4WD L4-1.6L VIN 6 (1998)
Overdrive Switch: Service and Repair
REMOVAL PROCEDURE
IMPORTANT: The Overdrive (O/D) switch is a part of the knob assembly. Replace the entire knob assembly if the switch is damaged.
1. Remove the console.
2. Remove the back terminals from the O/D switch wire coupler.
3. Remove the O/D wire harness from the O/D switch wire clamp.
4. Remove the two screws (13) that secure the knob assembly to the select lever tube.
5. Gently pull the knob assembly (1) in order to ensure that the O/D switch wire harness does not catch.
INSTALLATION PROCEDURE
