Tracker 4WD L4-1.6L VIN 6 (1998)
Four Wheel Drive Selector Switch: Service and Repair
Selector Switch Replacement (4WD Switch)
REMOVAL PROCEDURE
1. Disconnect the negative (-) battery cable.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Remove two screws, two plastic retainers and the rear console box from the floor.
3. Remove two screws, two plastic retainers and the front console from the floor.
4. Remove one screw and the gearshift control lever knob (2) from the gearshift control lever.
5. Remove eight screws, the boot cover and the gearshift control lever boot (1) from the gearshift control lever.
6. Remove one clamp and the gearshift lever case boot from the gear shift lever case.
7. Remove the gearshift control lever (2) from the gearshift lever case by pushing down on the gearshift control lever pivot and turning
counterclockwise 90 degrees (1/4 turn) and lifting up.
