Tracker 4WD L4-1.6L VIN 6 (1998)
8. Measure the resistance between the positive brush holder and the negative brush holder using the J 39200. If the resistance is 5.0 ohms or less, the
brush holder is grounded and must be replaced.
9. Measure the brush (1) length using the J 26900-& If the brush length is less than the minimum, replace the brush.
STANDARD BRUSH LENGTH
17.5 mm (0.67 in)
MINIMUM BRUSH LENGTH
12.0 mm (0.47 in)
10. Inspect the brush springs for corrosion or damage. Also Inspect the brush holder and the insulation on the positive plates for wear. Replace
components as necessary.
11. Measure the brush spring (2) tension using a J 544-01. If the brush spring tension is less than the minimum, replace the brush spring.
STANDARD BRUSH SPRING TENSION
