Tracker 4WD L4-1.6L VIN 6 (1998)
1. Power steering pump to mounting bracket; secure with mounting bolts. Do not fully tighten bolts at this time.
2. Engine oil filter.
Power Steering Pump Suction Hose
3. Electrical connector to pump pressure switch.
4. Suction hose power steering pump; secure with one hose clamp.
Power Steering Pump Pressure Hose
5. Pressure hose to power steering pump to secure with one union bolt.
Tighten Power steering pump pressure hose-union bolt to 40 Nm (29 ft. lbs.).
6. Engine skid plate, if equipped; secure with four bolts.
Tighten Engine skid plate bolts to 27 Nm (20 ft. lbs.).
7. Lower vehicle.
8. Drive belt to power steering pump pulley.
Adjust Power steering pump drive belt tension. Refer to Power Steering Pump Drive Belt Tension Adjustment.
9. Negative (-) battery cable.
10. Add power steering fluid to reservoir and bleed power steering system. Refer to Checking And Adding Fluid and to Bleeding System.
11. Check engine oil level and add oil if necessary.