Tracker 4WD L4-1.6L VIN 6 (1998)
4. Tie rod from center link using J 21687-02.
5. Loosen tie rod locknut at connector sleeve.
6. Tie rod from connector sleeve and tie rod end.
7. Locknut from tie rod.
^
Inspect the tie rod dust seal for perforation or excessive wear. Replace the seal if these conditions exist.
INSTALL OR CONNECT
1. Locknut to tie rod.
2. Thread tie rod into connector sleeve and tie rod end.
3. Tie rod to center link; secure with castle nut.
^
Tighten:
-
Tie rod castle nut to 45 Nm (33 ft. lbs.).
-
Tie rod locknut to 65 Nm (48 ft. lbs.).
4. Cotter pin to tie rod shaft. Bend end of pin following installation.
^
Inspect For proper toe adjustment.
5. Engine skid plate, if equipped; secure with four bolts.
^
Tighten the engine skid plate bolts to 27 Nm (20 ft. lbs.).
6. Lower vehicle.
