Tracker 4WD L4-1.6L VIN 6 (1998)
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
5. Tighten the stabilizer shaft-to-link nuts.
^
Tighten the stabilizer shaft-to-link nuts to 50 Nm (37 ft. lbs.).
^
Tighten the stabilizer shaft mounting bracket bolts to 25 Nm (18 ft. lbs.).
^
Tighten the stabilizer shaft mounting bracket nuts to 85 Nm (62 ft. lbs.).
6. Install the engine skid plate to the vehicle, if equipped.
7. Secure the skid plate to the vehicle with four bolts.
Tighten the engine skid plate bolts to 54 Nm (40 ft. lbs.).
8. Lower the vehicle.
