Tracker 4WD L4-1.6L VIN 6 (1998)
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
8. Use the hub bolts in order to install the J 42119-1 and the J 42119-2 to the spindle nut and wheel hub. Be sure to align the wrench with the slots on
the spindle nut.
Tighten the hub bolts to 2.5 Nm (12.12 inch lbs.).
9. Rotate the spindle nut counterclockwise two full turns in order to disengage the anti-rotation spring from the spindle nut.
10. Remove the J 42119-1 and the J 42119-2 from the wheel hub.
11. Remove the following components from the spindle:
^
The spindle nut
^
The anti-rotation spring
^
The spring back-up plate
12. Use the J 37781 with the J 2619-02 in order to remove the following components from the spindle:
^
The wheel hub (1)
^
The wheel hub bearings
^
The oil seals
